3/16" Roll Stripe 150 feet long from Sharpline Converting
This is the same as Sharplines Prostripe.
This kit includes a 150-foot roll of pinstripe made from 2mil high performance automotive vinyl. Use to customize and accent your vehicle.
The pinstripe is 3/16” (quarter inch) overall width consisting of one 1/16” stripe and one 1/16" stripe separated by a 1/16” gap.
A clear overtape holds the two consistently spaced and easy to appy.
Film: 2.0-mil premium cast vinyl with clear, acrylic, permanent, pressure-sensitive adhesive.
• Liner: 78# white kraft.
• Exterior Durability: 9 years*.
Sharpline has been a leading innovator in designing and manufacturing the automotive aftermarket’s highest quality graphic products. In addition to our exceptional automotive graphics, Sharpline produces hundreds of thousands of rolls of professional roll striping, available in over 70 popular colors and ready for immediate shipment.
If your looking for the best product that will last for years, then you found what your looking for.
I send a card with the URL for full instructions, vehicle prep and install video.
1. Preparation & Environment
- Ideal Temperature: Apply in a shaded area when the surface temperature is between 60°F and 80°F. Avoid direct sunlight, which can over-soften the adhesive.
- Surface Cleaning: Wash the area with soap and water, then thoroughly clean it with 70% or 91% isopropyl alcohol or a dedicated Wax and Grease Remover. The surface must be completely dry and free of wax, silicone, or oils.
- Design Layout: Use 1/4" masking tape or a similar guide to mark your intended line. This ensures the pinstripe stays straight and symmetrical across body panels.
2. Application Technique
- The Dry Method: For 3/16" narrow tape, the "dry method" is standard. Peel back approximately 12 inches of the paper backing at a time.
- Tension is Key: Hold the tape taut with light tension as you lay it down. This prevents wobbles and ensures a smooth flow. Do not over-stretch the vinyl, as this causes it to shrink and lift at the ends later.
- Adhesion: Press the tape down lightly with your thumb or a felt-edge squeegee to secure it. Work panel by panel to maintain consistent alignment.
3. Finishing & Trimming
- Trimming: Use a sharp razor blade or utility knife to cut the tape at door jambs and ends. Leave a small gap (approx. 1/16") from the edge of the panel rather than wrapping it around the corner, which can lead to peeling.
- Remove Carrier Film: This tape usually has a clear protective top layer. Once the pinstripe is firmly pressed down, peel this film off slowly, pulling it back over itself.
- Heat Sealing: Lightly warm the applied tape—especially the cut ends—with a heat gun or hairdryer on a low setting to fully activate the pressure-sensitive adhesive.
4. Aftercare
- Curing: Wait at least 24 hours before washing the vehicle.
Avoid High Pressure: For the first 7 days, avoid high-pressure car washes to prevent the water from catching and lifting the fresh edge